Scuba Diving Gears

Scuba Diving and Gear

2007-08-28T08:27:00.000-07:00

Before going on a trip to scuba dive, check your gear and tanks. You may think they are fine, but it is better to be safe than sorry. I had made a 7 hour trip to Florida to do some dives with my son and daughter-in-law. Once we got there, my son decided to take us to a dive shop and buy some diving skins and other stuff we needed. My husband ask the owner of the shop to top our tanks off with air. Well, the guy lets all the air out of our tanks to do an inspection. Our tanks were due to be inspected in two months, but the guy said he always checks the tanks before he fills them. Thank goodness he did. My 2 tanks were good, but my husbands 2 steel tanks had rust inside them. That could have been dangerous for my husband. It turns out, the place I got the tanks fill at the last time had water in their air lines and it got in the tanks. The owner explained to us that he only does good work and follows the rules when it comes to peoples lives. He showed us his license and all the charts and all that goes with it. He is quite reputable. It all ended up with us leaving his tanks and a lot of money, but his tanks will be good to go when the owner gets done cleaning them.

We ended up borrowing tanks from the shop to make these dives. Finally we get on the boat and head out into the ocean. It was a beautiful day, sun shining bright and water all around us. Dolphins and manatees swimming in the water.

We get to the spot we want to dive. A plane and a ship is sunk in this spot. I can't wait to see all this. My husband hooks his regulator up to the tank and checked it, to make sure the air was flowing right. I am so glad, turns out the regulator was on free flowing and wouldn't adjust. He hooked mine up and the same thing, stuck on free flowing. Well, there went my diving. My husband used my daughter-in-laws regulator and did the dive. Her and I sat on the boat and waited for them to return.

I did have a good day, even though everything that could go wrong, went wrong. I didn't mention the boat stopped running while we were on our way out there, junk in the fuel filter, and I got sun burnt.

Once we got back home, my husband took our regulators apart. Ends up that there was sand and junk inside them from previous dives. We rinsed the equipment after every dive but I guess we didn't clean the regulators good enough. This could have been a very dangerous dive if we didn't get our tanks checked and if we would have dived and the regulators messed up while we were 40 plus feet underwater.

So, if you are a diver, please get your equipment checked. And after every dive make sure you wash your equipment and get the sand out of your regulators. This practice could save your life...Continue

Article Source: http://EzineArticles.com/?expert=Lenore_Chapman

Buying Scuba Diving Equipment - What To Buy First

2007-08-28T08:25:00.000-07:00

By Ruby Bluebird

So you have taken your course and done a bit more diving and want to invest in some scuba diving equipment, but where to start?

A common question I am asked by new scuba divers is, "What scuba diving equipment should I buy first?" It can be tempting to want to buy all the kit in one go but it is a big investment to make and if you are only going to be diving two weeks each year on your holiday it might not be the best use of your money.

I always advise people to wait a while before buying any equipment, in this way you have time to see how often they will be diving, where and when they will be diving. In that way they can be sure to be spending their money wisely.

Mask, fins, snorkel.
A mask, snorkel and fins are a great basic investment. They are relatively cheap, lightweight, easy to carry on trips and can also be used for snorkelling.

With a mask fit is important, find a local supplier or club and try a few different styles. Small faces, big noses, wide set eyes, everyone is different. To check for a good fit hold the mask up to the face and inhale through your nose, a mask that fits will stick to your face.

If you wear glasses you might consider a mask that can be supplied with prescription lenses, they often aren't much more expensive to have fitted and can save the trouble of contact lenses on the dive site.

Snorkels come in lots of styles too and it is down to your personal preference.

Fins, again lots of styles to choose from. The main consideration I would make would be full foot or strap fins. Full foot fins are great for warm water diving and boat diving however if you have strap fins with boots your feet will be warmer and you can walk more easily over different terrain.

When you start buying scuba diving equipment you will find that there are many different styles to choose from. It is important that you get good advice from your supplier and are not sold something that you do not need. Be wary of sales people that don´t listen to you or try to get you to buy only one particular brand. If you are a member of a club ask other members if you can try on kit to get a feel for things.

Buying scuba equipment online can be a great way to hunt out bargains especially if you don´t have a supplier close by. However where fit is important, say for masks, make sure they have a returns policy or you have tried the mask in a local shop first and know it fits before hunting for a bargain online.

Remember, whatever scuba equipment you are buying be sure that it fits you and suits your needs as well as your budget.

Just started diving and having trouble finding your fins? Get expert advise and news about scuba diving at http://www.scubadivinglife.blogspot.com

An Introduction To The Scuba Diving Tank

2007-08-28T08:20:00.000-07:00

By Darren Lintern

It is well acknowledged that the scuba diving tank is a canister that supplies air to the diver while underwater. But further to performing that apparently simple, singular role there is much diversity. For a plane metal cylinder, diving tanks have an astonishing number of variations.

With the exemption of certain exclusive models, all dive tanks are prepared from either aluminium or a steel alloy. Specialized sport diving, military applications and technical diving will occasionally use a chrome molybdenum alloy. All styles have their own positive and negative points.

Aluminium tanks are the lightest, although the notable difference below water is minimal. The disparity becomes more significant after taking into account the amount of effort that's involved in shifting them between dive trips. Aluminium air tanks also commonly have positive buoyancy that may need to be remunerated for with the addition of weights. This detail somewhat puts a stop to their lighter weight advantage verses that of the steel tanks.

Aluminium tanks are typically less costly than steel and more widespread, but the latter are likely to have a longer shelf life. Suitability maintained steel tanks can last thirty years or more. Many dive stores will decline to fill an aluminium tank over fifteen years of age.

Steel dive tanks were by tradition heavier, but a great deal less prone to rupture or puncture, denting or scratching. Modern-day steel tanks are to a great extent nearer in weight to aluminium ones, as they can be prepared thinner while maintaining ample stableness. More significantly, the threads on the neck of a steel tank are much less liable to get exposed from constant replacement of the regulator kit.

Although a steel cylinder can rust in the shape of iron oxide, aluminium can corrode as well, creating aluminium oxide. Neither is of serious risk to your health, but both ought to be maintained at regular intervals to abolish any contaminants. Aluminium will need this at less frequent intervals.

The vast majority of dive tanks hold approximately eighty cubic feet of compressed air. A variety of outsized models do exist, for those larger divers or anyone that needs an extra large capacity for extended dives.

Auxiliary tanks, most often referred to as pony tanks are needed as a back-up in case the main is emptied or fails. Auxiliary tanks can hold approximately sixty-five cubic feet of compressed air. Pony tanks tend to be secured with a separate belt.

Any scuba diving tank, suitably cared for, will last for many years of dependable service. Bearing in mind what actually depends on it; take the time to research your acquisition carefully.

Darren Lintern writes extensively for www.andallabout.com, a popular informational website that provides helpful tips, advice, and resources on many scuba diving topics including Scuba Diving Masks, and Scuba Diving Locations

Article Source: http://EzineArticles.com/?expert=Darren_Lintern

Scuba Diving Flippers Can Be a Real Pain

2007-08-28T08:17:00.000-07:00

By Matt Hunter

In the early days of scuba diving, there were not many choices for flippers. Today, with all of the advances in technology and years of testing, there are numerous options from a variety of different manufacturers.

Regardless of the cool looking style or fashionable colors of the flippers, the most important thing to pay attention to is fit (and comfort). Be sure to try out several pairs until you get one that is very comfortable and not too loose. Loose flippers can quickly cause irritation and blistering after just a few dives.

Many flippers are specifically engineered to give you the maximum thrust with the least amount of leg effort. Some of these more efficient flippers are commonly known as "split" flippers. These types of scuba diving flippers have a slit near the middle which "splits" the flipper into two sections. While there are many new fancy types of flippers available, many scuba divers still prefer the basic traditional flippers.

After selecting the size and fit of flippers that is comfortable, you can then begin to look at the many different styles, designs, and colors. There is a tremendous variety when it comes to these attributes. The options are all pretty much a matter of your style and taste on what you prefer. Some divers like the flashy neon colors with the dazzling intricate artwork while other divers like the calm simple earthy colors without a lot of pizazz and flair.

If you are a serious scuba diver, you are going to want to get a good quality pair of flippers that will last a long time. You also need to take good care of them so they do not dry out and crack after a few uses. Be sure to do the proper maintenance on them and store them in an appropriate way to keep them in good shape for many dive adventures.

It is a great idea to take the flippers out for a test dive if you can. If you are allowed to return the scuba diving flippers after purchasing and using them, you can buy them and take them for a dive excursion or two to see if they are comfortable and don't cause any irritation or discomfort after the dives. If the shop does not allow returns, it would be wise to try to rent a pair and test it out before making the purchase.

In the end, it all boils down to what your preferences are in scuba diving flippers and what will work for you. Whatever you decide, be sure you choose a pair that is very comfortable so your scuba flippers don't end up being a literal pain.

For more information about scuba diving flippers try visiting http://superscubadiving.com, a popular scuba diving site that provides many tips and resources about all kinds of gear such as masks and scuba diving watches.

Article Source: http://EzineArticles.com/?expert=Matt_Hunter

Scuba Diving Tanks, Which One For You?

2007-08-28T08:12:00.000-07:00

By Dorothy Santoro

Advances In SCUBA Diving

Whether you are a sport diver, an old pro, or a new diver looking for lessons, SCUBA diving has something for you, and your SCUBA tanks are a vital part of the diving experience. Today, we can hardly remember the time, before Jacques Cousteau, when divers didn't have ‘self contained underwater breathing apparatus' to make it possible to dive for extended time periods, for recreation or emergency rescue situations.

It's amazing to think of the advances in underwater gear in the last 60 years. It is hardly possible to turn on the TV without seeing a program with a diver in SCUBA gear.

Without SCUBA tanks businesses, like offshore oil drilling would not be possible. Exploration of the oceans, which cover most of the planet, would also not be taking place. Rescue and recovery emergencies would be much more difficult, if not impossible without SCUBA gear.

Breathing underwater for longer periods is made possible with the utilization of scuba tanks. While all Scuba tanks serve the same purpose, they come in various shapes, sizes, materials, colors, and pressure ratings.

Scuba tanks, bottles or cylinders, whatever you happen to call them, allow the diver to have his or her own source of air and normally, in recreational diving the breathing gas is air. Scuba tanks can be short and fat or long and skinny and hold different amounts of air, usually, between 50 and 150 cu ft of compressed air, though some bottles can hold as little as 25 cu ft.

Different sizes and amounts of air in a SCUBA tank are made like that for different purposes. Be sure to get one suited to you and the type of diving that you are doing.

Aluminum Or Steel SCUBA Tanks

Scuba tanks are made out of steel or aluminum. Aluminum scuba tanks are normally used and are less expensive, but they do suffer some disadvantages though, as it is softer than steel and more likely to suffer damage with rough or careless handling and steel scuba diving tanks take punishment better and generally can last longer.

Though some dive shops don't like filling aluminum tanks after 15 years or so, steel tanks are normally good for 30 years or more. If your buying your tanks new, you won't have to worry about replacing them, except for damage, for many years to come.

Be Safe

There are some security measures to be taken in dealing with SCUBA tanks, such as, securing scuba tanks and other dive gear on boats and on land, it only makes sense, even though many more people are killed by drowning or bee stings worldwide than scuba tank explosions. One of the places you don't want to have any problems is out in the water.

Another security measure that you wouldn't want to ignore is inspections. SCUBA Tanks must undergo several types of periodic inspections, like being hydrostatically tested every five years (60 months).

Scuba diving is a wonderful sport for beginners and veterans alike. But, scuba diving is a sport in which the gear is one of the most crucial elements to the adventure. Do your research and get advice on your SCUBA tanks from your instructor, keeping in mind, that breathing is the most important thing that you do, because without air, nothing else matters.

SCUBA Diving Tanks are the most important piece of gear in SCUBA diving. For more information on diving and other outdoor activities, check out http://www.SCUBAdiving.outdooradventuretoday.com

Article Source: http://EzineArticles.com/?expert=Dorothy_Santoro